Search results

Dan, what regulator did you use?

The inverter was wrong. The clutch and fan came on as soon as I grounded the wire. Thanks Allan. I agree with you Dan, I had installed easier A/C units.

Thanks Allan. Will give it a try.

Been working trying to resolve an issue with the Vintage A/C unit is not working. The A/C clutch is not engaging and the Infinity Rear power cell light number 10 is not appearing when power is supplied. I have checked for the Inverter in the wiring for the fans control and it is there. I tried...

I also would be interested in a VIN plate

Thanks for the info

What mesh should I used to cover the airbox and the side inlets? Part number and where to purchase would be appreciated. Thanks

Thanks Kevin. I have it.

Anyone have a heat shield bracket for the Graziano they want to get rid of? I took mine off and can't find it. It's the bracket on the driver's side of the Transaxle. Thanks

I broke mine and have been waiting for over a year for a replacemen from RCR. I too am looking for a windshield.

What cables did you use? Ones supplied by Fran or custom cables. If they were custom where did you get them and was there a part number. Thanks

In the March Car and Driver there is a good acticle on a Mazda Miata with the LS3 engine. Very tight fit. In looking at the cold air tubes there is only 2 90 degree silicon tubes. Could there be a different throttle body not requiring the 10 inches for the installation of the mast air sensor...

Before I started the SLC, the KOSO unit was working normal. The turn signals, high beams and I could set-up the engine parameter. Since, the start, the KOSO goes through it start-up function then it just shutdowns. I have checking the 12volt and the ground connections and the KOSO is getting...

As suggested I filled the swirl tank with the low pressure fuel pump and after a few hits with the starter the car fired up. Oil pressure was 50. I did have a couple of oil and antifreeze leaks that need to be looked at. I also have a problem with the KOSO. It was working before I started...

I am close to starting my SLC and would like to know if there is anything I need to do to prime the fuel system. I have the typical high and low fuel pumps and the swirl tank.

Can you tell me what transaxle fluid I should be using in the Graziano transaxle. I am sure it's been discussed but can't find it. Thanks

Thanks Ken In further investigation, the paperwork that came with the engine said to remove electrical power to the engine, put in oil and crank engine for 10 sec and look for oil pressure if no pressure wait 30 seconds and do again until you get pressure. I guess I built a pre-lube tanks...

Does any one know what the plug dimension behind the alternator for pre-lubing an crate GM LS3 480HP is? I thought it was 14 MM but the socket Allen wrench to take it out is 17 MM. Thanks

The MAF sensor that goes into the intake tube. The part on the box is correct 1586791 but the sensor is wrong. I talked to JEGS and they had me contact the GM performance people. The sensor number for the correct part is AFH70M-43A. The one they sent me is AFH70M-38. GM performance told me to...

Background, I have a GM crate engine and their wiring harness. I when to plug in the MAF sensor and the wiring connector has a different plug. The plug is too big for the sensor. Another quality issues. Has anyone had this issue and if so can you tell me what MAF sensor I should use. These...