Search results

Does anyone know the part number for the shift cable retainer clip on the Graziano transaxle? It's must be a small "C" clip. It holds the cable on the transaxle.

On the LS3 passenger side there is a uncapped tube I believe is part of the PCV system. Should his tube be capped, plumbed into the Cold Air tube or plumbed into a oil catch can then into the Cold air tube? Please advise. Getting near to hear noise!! Thanks

Pete Can you provide details on how you interfaced the GS-5 -2 to the KOSO with settings and wiring. I would like to do the same. Thanks

Thanks Pete

Thanks Ken I saw the cable. My question does it have 4 pins or five pins. The picture shows 4 and the switch needs five.

Pete Thanks for the pictures. The wire that you installed, it is for the light? It looks like PIN #4. If you use the Pin #4 for your reference, what PIN did you connect the ISIS power and ground. I did a GOGGLE search for ISIS and the Honda S2000 and it indicated pin #4 ISIS Mastercell and...

Outstanding job. The book is worth the price.

Does anyone know of a female connector with the five pins for the Honda S2000 push button start switch? If not, for those who have the button, how did you wire them. Also, can you tell me which pins you used. I believe you would wire the ISIS power to #4 and ground to #5 looking at the back...

Bill thanks for the information. Can you tell me where you purchased the "C" shaped weatherstrip and the part number? The car is awesome!

I did the same as Aaron, took a couple of hours but it was not hard.

What monitor are you using?

Is the vapor vent from the radiator necessary? Most production cars don't have them.

For those using a keyless push button starter switch, what switch are you using?

To fit the dash around the rollbar, I cut the corners off the dash. Now there is a big area exposed to the chassis. If I fiberglasss the pieces I cut out in place I won't be able to take the dash out. Looking for suggestion.

Just a heads-up on the bulkhead connectors. I found two wires out of place on the connectors. The pink and tan wires were mis-pinned to the male/female connectors. This would have affected one of the fans and the hydrualic pump.

I am waiting for my fan shroud to be completed and was wondering if a air deflector would help in deflecting the hot air away from the cockpit. I made a deflector out of a piece of scrap sheetmetal that the shroud is being made from. Since my battery is mounted in the front of the vehicle...

My mistake it should have read tach. But the question is the same. Can I use a 5.1K or a 4.7K 1/4 watt resistor? Or can someone tell me where to look for a 5K ohm resistor? Radio Shack and Mouser do not carry them.

I have been looking for a 5000 OHM-1/4 watt resistor to work with the KOSO Dash Meter. I have found 1/4w 5100 ohms resistor and a 1/4 w 4.7K ohms resistor. Can any of these work?

Yes they changed the design. The way I ran the a/c lines was to use a 90 degree on the smaller fittings #6 hose and a straight fitting on the larger #10 hose. I have the #6 coming in from the dryer in the front of the car and run the hose along the top of the inside of the passenger footwell...

Can someone confirm that for the latest steering column supplied by Fran these are the parts required Quick Release SRK-250-BK (black) and for the short hub SRK-170H. The column is non power, tilt only. Thanks