Search results

James the next mtg is june 4th at the Toby carvery, stonebridge island near the NEC/national motorbike museum. Call me.anytime if you want to meet up there or just pop along from 8.00pm

Hi James. We have a GT40 club regional mtg in Birmingham. Your more than welcome to come down and discuss your build ideas. Between us we have quite a few cars and a lot of good advice. If you want to chat call me on 07508 442273 ! Best of luck.

Hi Dave. Thats great information thank you. If I find out an alternative i'll let you know.

Hi all I want a softer street based pad that will work from cold. I would like to talk to Willwood about options but I don't know the name of the callipers we have fitted to our cars. Can anyone confirm if they use the Forged Dynalite ? I understand the pad would need to machined down due to...

Hi there, sorry it sold

Viking blue ? , good choice :)

Thanks steven. Yes mine were routed the same from the factory. Unfortunatley i cant do what you have done ( route sharply to the side of the pulley) because my cable simply isnt long enough. I pulled both cables off today after trying every possible route i could think of. I noticed the driver...

Hi ian. The Superformance doesnt use callipers it has a drum type arrangement and comes pre fitted with cables on them. The only solutions i can think of are routing the cable directly in between the belts for a more direct route ( not great ), or relocating the cables in front of the rear...

Hi bill thats exactly where mine runs

Thanks all. U fo Looked at that rick but that just shortens the effective length of the cable and makes it tight. There isnt enough length in the cable to do that.

Hi all Having just installed the motor into P2378 I have noticed that the handbrake cables are touching the crank pulley. Im using a 2 row v belt pulley to work with the supplied Hi tec ancillary brackets for the alternator and aircon. I have the cable's routed from the chassis brackets as they...

Sorry all , item now sold

Thanks for the replies guys. Sound's like my proposal will work just fine. Howard. Im planning to run without the controller (just controlled via a dashboard switch and off the ignition circuit.) I was advised by DC to try a thermostat with 2 off 5 mm holes in it, so I might try that first. Im...

Hi Mark. If your in the UK , I would google Tony law exhausts in Leeds. They make the best one and its not too expensive

Hi All. Im looking to fit a davies craig remote type Water pump up the front end of my SPF 40. Attached is a diagram for the SPF cooling system. Upon deletion of the mechanical pump , I need to reroute pipework that would normally go to the 2 smaller water pump outlets on top of the pump. I know...

Double glazed glass rear window as sold by Tornado cars but would probably fit others such as GTD and SGT etc. Window has never been used. Comes with a glass fibre frame but this has some drilled holes that may need to be filled for your application. Call Jason on 07508 442273 £120 collected...

Hi , Who supplies that ? and do you have an approximate cost ? Do you have a picture of the reverse side, ?interested to see if the spinner lugs are protected some how ?

brilliant thanks

Thanks Rick Do you know the Glasurit code that SPF use? , there are some Glasurit stockists in Europe i could contact if i knew the code

Hi all I need to get hold of some Viking blue paint. I believe it is Glasurit supplied. Does anyone have any paint codes for it ? thanks