Search results

Joel, I sold my car a year ago so I can’t take any measurements, sorry. That said, don’t do any body fitment without having the windshield installed (not final but taped in place). I remember when I was doing my final fitment, took me a month fore sure and when I was satisfied with it all and...

Thank you.

Just watch out if you are planning H’s mod of moving the upper shock mount. There is a chance that the lift pucks don’t have enough room if you’re planning to use it. The Ramlift might fit but I don’t think the Viair fits.

Thank you.

Michael, do you remember what spring rate you ended up buying for the fronts? RCR sent me 850lb, way too much.

Kurtiss, didn’t know you had a Youtube video. Do you have a link?

Price is around $400 +/- depending on shipping cost. Brackets for Pierburg CWA400 (and CWA200 I think) and hose barb included. Made in the Netherlands and a minimum of 2 set for the above price due to material cost. I will supply email info if anyone is interested, just pm me and I’ll forward...

Will do, sby.

Bracket for Pierburg CWA400 and hosebarb included.

If anyone interested I have one for sale and can get you in contact to supplier. Perfect if you are using EWP and discard the mech pump.

Yes, the GT-R uses the same bear claw. However the are mounted left on the right side and right on the left.

Don’t know who’s admin for this site, but if isn’t Fran, I can only say I’m seriously pissed. I have been so screwed on delelivery time (both on the SL-C and GT-R but it’ok) and not delivered parts.. Still waiting on steering rack for the GT-R . My GT-R ordered March 2021, still no rack. After...

I don’t think those are for LS, here is the LS mount.

Joel, with the tie rod that close to the upper control arm (height wise) you shouldn’t have it paralell with the LCA. Check this out. There is a lot to read about bump steer.

Same as Scott, I’m using copper nuts. OEM’s has done it for centuries, can’t be wrong.

I would love to hear that engine. Back in the early -80 we were dragracing and our nabor team had a dragster with 8 to 1, quite a different song, almost like a flatplane.

Nice work Stephan, I did it pretty much the same exept the other way around. I extended the dash around the cut outs to reach the duct and then some bulb seals.

Here’s a link to the Magnum Shooters. Comes in 1-5. But these are for inside door electronics, if you intend to control a doorlight only I would hide the switch inside the body, accessible from the cupholder...

Thinking of what Mike said, couple of years ago I had a problem when decelerating with closed throttle (engine braking) and when I pushed the clutch the engine sometime died. Ended up re-mapping with Alpa-N in the idle area. A while later I had the intake off for another reason and installed new...

Rich, best routing would be: Tank(swirl or not)-100micron-Pump(if not in-tank)-10micron-Fuel rails-Regulator-Tank. That way you get the desired pressure into injectors and a constant flow through the system. (No vaporlock)