Search results

Well done Nick all your hard work paid off regards mick.

Well done Glen and Tammy now you will need a bigger wall to hang them on . Regards Mick

Hi Jonas I think there is some confusion over flywheels if you use the Zfq bell housing you will want a 157 teeth flywheel from a v8 our flywheel is smaller it is fitted to sgt cars using original size Zf bell housing you can use our flywheel but would require a different starter motor...

Hi J the panels are normally fitted first . Regards mick.

Hi Andy the reason this happened was because there was no room for expansion between the outer diameter of the splined shaft and the alloy upright Both uprights are being machined to correct this and all parts will be checked and re assembled. Regards Mick.

Hi all just to make it clear the SGT car that had the issues with the cv joints was caused by incorrect length gearbox adaptors being fitted which were not supplied by sgt. Regards mick.

Well done Andrew just registration then your off . Regards mick

Hi John i have come across 2 different lenghts of input shaft tubes that take the oil seal behind the bellhousing make sure yours is not to short as the seal will not fit tight up against it causing large oil leak. Regards Mick.

Hi Mark you are welcome to visit southerngt anytime just give me a call. Regards Mick.

Hi Martin your pulleys and alternator will not fit .The sgt back end will allow you to lower engine and gearbox but will not stop the problems you will have at the front with the set up you have in your picture .The stacks also do look long. Regards mick.

Southerngt wish to make it clear that the chassis on this car is not a sgt it was a kva the front end has been built by us and fitted at the factory. The back end was supplied out as a seperate part so any future purchaser should be aware that sgt are not responsible for the correct positioning...

Hi Bob we run low pressure pumps to the swirl pot then to a filter and hp pump runs faultless . Regards Mick.

Hope you get well soon . Best wishes from Mick,Adam,Carol and Stevie.

Hi Glen well done will make you a reinforced cabinet to put your trophy in. Regards Mick.

Hi Tony hope the trip back was not to bad will contact you when i have the prices for the other parts. Regards Mick.

It must be something in there water overthere as we all seem to have sold cars to sweden. mick.

Hi Keith you are welcome any time we are in curbridge,botley, hants just give us a call or email. regards mick.

Nick dont worry we have all parts for IVA. Regards Mick.

The john wisher bellhousing is for the smaller flywheel .We keep machined steel billet flywheels in stock 121 teeth that fit (neutral balance) . regards mick.

Hi scott did you recieve my email we can supply. regards mick.(southerngt)