Search results

Markus, you are correct, I had spaced all of that information out but when I sent the post it compressed it. I used these same Longacre scales to weigh the CAV, the only difference is about 10 gallons of fuel. Dave

The SPF MKI is up and running so it was time to put it on the scales. MY CAV #56 weighed in at a porky 2840 lbs with me and 15 gals of gas and I thought the new car might be a lot lighter. The body panels, seats and bellhousing, flywheel/clutch combo are all lighter on the SPF. LF...

It doesn't appear to me that we know what has failed. A steel distributor gear running on a billit cam is not going to fail in the time it takes to pump oil to it. I always fill cooler and filters but even so I think you would damage bearings before the dist/cam gears would go, unless it had...

These guys are all great! But racing is like flying, it's easy, the machine does all the work!

Henry You will need a 90 degree adapter for the cable, Stewart Warner makes one that works. You can get one from most speedometer repair places. After you install the adapter be sure that it turns in the speedometer, the end that went into the speedometer was too long (on the one I purchased)...

Hello Ian, I am interested in shipping my SPF over for the 2010 Le Mans, please keep me in the loop on that. Thanks, Dave

Frank, don't you have a similar old car of your own? Dave

If the lines are wrapped around each other then you will need to diconnect one and reroute it. Where are you located? I have a vacumm pump and gauges for a 134 system, if you can bring the car here (San Diego) I can help you with recharging it. Dave UOTE=Gulf;259263]Help with lines...

Obviously.

This time I will read what I have posted. [email protected]. Please send some photos and any additional information you may have on the gear box. Thanks, Dave

Further updates on #2214. I was able to run the car for about an hour before the MSD 7530T expired, I sent it back to MSD, they repaired it but it failed the burn in and they are sending me a new box. Should be able to update this build next week. Dave

I am interested in your gear box, e-mail is [email protected] (619)339-3838 Thanks, Dave

I have 2 of those wrenches, I shortened the handle of one so it would fit, worked great. Dave

I had this same issue w/2214. I had to adjust everything down by the pedal plus I had too tight of a bend infront of the engine(Weber throttle pull is in the center, pulls from the front, not the side). I also added a compression spring over the end of the cable so that it would push back. I...

You are absolutely correct about these online product orders, my girl friend fell for the Money Back Guarantee on some bogus clothes hangers, she took the offer for the "free" extras, when she received the pieces of crap she immediately returned them but the shipping and handling was about $50...

I will second the Leather jacket!

Hi Mike (Foowowee) I spoke with Lance about your T-shirt issue. Here is his cell phone, (714)330-3297, he says just call him and he will give you 2 free shirts and ship them for free as well! Dave

Hi Tim, they did arrive and the Beast is alive! I need to make a new heatshield for the Webers and then I am ready to rock n roll. Can you tell me who did the 3M clear chip protector on your car? I would like to get that done soon Thanks, Dave

It only cost $21.00 to ship a box of exhaust pipes from Hilbank to Ramona, how can shirts cost $28.00? Dave

Summit sells a 100 amp, single wire, Ford alternator that will work. Olthoff sells polyeurthane motor mounts, that is I used. Dave