We are now on the wiring on the car. And we dont really know how to connect the Accel DFI 6A module to the ignition coil. Does anybody have a Picture of his Installation , that would be very nice.
Have a nice week
greetings from switzerland.
Hello together
I have a question about the shifting directions.we would Like to install the shifting cables. Does someone have a diagram where the gear positions are On the gearbox axle?
Thank you
Greetings from switzerland
Hello together
we have a Roush 427 IR and we need exhaust system but without muffler for our GT40.
Is there somebodey who is selling, or somebody who knows where to buy?
Thank you for help.
Greetings from switzerland.
Hello together.
Is there anybody who has installed to his roush a dry sump?
it s a windsor block . does anyone have cut drawings for measurings?im searching the measurement of a dry sump pan for installing the engine.
greetings from switzerland.
Urs
Hello together.
Im searching a bearing to fit my ZFQ to the roush 427 IR with mcleod clutch.Where can i get this bearing (s).Has someone the same configuration?
Thank you for answering.
greetings from CH Urs
Hello
we try to build the suspension now.Has anybody measurings of a vintage wheel spinner? we put on 17 inch brm Wheels.Are there also measurings existing from the wheels? it would be nice to get a cut drawing from wheel and spinner.I hope there is someone who knows an answer.
thank you...
Hello together
Is it possible to get a dummy of a gearbox like ZFQ measurings?
because we have to build up the chassis hinge points from engine and transaxle.
Now we started with the build of a carbon mono of a gt.It s a great challenge !I hope we could do it to the end!
We start with the forms of the bottom and the tank Radius.