output

I have read that its preferable to use AN4 size rigid tubing (with 1/4" ID)to the external slave clutch cylinder from the clutch MC on a ZF tansmission as it allows a better flow back and forth of fluid. But since I have a wilwood MC that has an output of 3/8" -24 which would appropriate for a...

I’ve just purchased MDA GT40 with a Renault UN1 gearbox, are the output shafts meant to float? The hubs that slide over them appear to move horizontally on the output shafts too, this alone seems a little excessive as though the lock pins have been omitted? Thanks in advance:uneasy:

I have an Icknield rev counter which was connected to the old distributor contact breaker. Will it now work with my Emerald K6 ecu which gives a 0-12v pulsed output? Just in case the answer is no you will kill the rev counter. :stunned: Dave