shafts

I’ve just purchased MDA GT40 with a Renault UN1 gearbox, are the output shafts meant to float? The hubs that slide over them appear to move horizontally on the output shafts too, this alone seems a little excessive as though the lock pins have been omitted? Thanks in advance:uneasy:

Hi Everybody I hope Iam posting in the correct section. I have an Audi 012 gearbox which is being used as my transaxle and hoping to use the audi half shafts as well. I am using a Corvette's C5 rear suspension and uprights. I need to adapt the half shafts to fit into the corvette upright or hub...