Dont worry , Im not going to ask about every little slot or hole ,LOL.
I was laying out the rectangular slots for the seatbelts to pass through the bulkhead , and they seamed kinda big.
The dimension is 70 mm wide x 25 mm high, located 40mm from horizontal edge of the bar and 45 mm down from the cross brace. In this picture below from the RF site there are two chassis. The one on your left seems to have the hole dimensions stated above . The right chassis has much thinner openings and they seem to be located with the top edge in the same spot. Are the larger openings not needed ?
Please advise and thanks for the help. Dan
I was laying out the rectangular slots for the seatbelts to pass through the bulkhead , and they seamed kinda big.
The dimension is 70 mm wide x 25 mm high, located 40mm from horizontal edge of the bar and 45 mm down from the cross brace. In this picture below from the RF site there are two chassis. The one on your left seems to have the hole dimensions stated above . The right chassis has much thinner openings and they seem to be located with the top edge in the same spot. Are the larger openings not needed ?
Please advise and thanks for the help. Dan