little end /wrist pin bushes

[Tim]

I've new bushes that are slightly too tight on the pin, can you use an abrasive to relieve high spots in the bronze bush ( I realise the danger of making them out of round). Will sharp particals be embeded in the bronze?
I don't have a reamer & I think the ends have closed up very slightly after being carefully pressed in. thanks

 

[Jac Mac]

Take em to a machine shop & pay to have them honed on a machine setup for the job, trying to do that by methods along the lines your thinking off will only cause you more trouble, rods should/must be checked for alignment during this work.