Hi Guys I need some help.
I have a Kennedy bell housing to suit a 157t flywheel (pic attached). I have a 327ci Windsor (aiming for around 350hp) going to an RBT.
Will a standard dimension 157t Ford flywheel (I require 28g balance) work? I understand the clutch will not be standard due to the RBT spline size however, I would like to go generic if I can, say a McLeod flywheel and clutch package via summit racing? I have the external clutch release kit from Lloyd so I do not need a hydraulic throw-out bearing.
Does anyone on this forum have this combination or similar? Can you please share your part numbers?
Also the bell housing did not come with a sandwich plate, I think it should (to assist with alignment and provide a cover for the lower portion below the engine block). Are sandwich plates mandatory?
What starter motor fits this housing? The bolt centre's are 132.5mm (5.2165 in) Again any info would be appreciated.
Thanks in advance. :thumbsup:
Kind regards, Gus.
I have a Kennedy bell housing to suit a 157t flywheel (pic attached). I have a 327ci Windsor (aiming for around 350hp) going to an RBT.
Will a standard dimension 157t Ford flywheel (I require 28g balance) work? I understand the clutch will not be standard due to the RBT spline size however, I would like to go generic if I can, say a McLeod flywheel and clutch package via summit racing? I have the external clutch release kit from Lloyd so I do not need a hydraulic throw-out bearing.
Does anyone on this forum have this combination or similar? Can you please share your part numbers?
Also the bell housing did not come with a sandwich plate, I think it should (to assist with alignment and provide a cover for the lower portion below the engine block). Are sandwich plates mandatory?
What starter motor fits this housing? The bolt centre's are 132.5mm (5.2165 in) Again any info would be appreciated.
Thanks in advance. :thumbsup:
Kind regards, Gus.