Search results

Dash populated now got to wire the bugger up!!

Vote over all 3 of the ladies in my house (now you know why I have a workshop) loved it so it stays and actually with dials going in its really growing one me, will finish the dash and send some pictures over, cheers all

Nice inout chaos, car will be No 6 Gulf colours hence his thoughts on a bit of razz, I know what you mean Andrew but I found that dash moulding not to be the best and it would have been hard to get I think those covers to fit well for them to be non trimmed, I wanted maybe alloy but again very...

Just got my dash back great job, chap did a bit of a wild card, blue stitching and orange centre to match my colour scheme, at first I was not smitten but its sort of growing on me so take a vote. He said its easy to change, rest of my interior is going to be quite stripped out, bare floors...

Pretty much :)

Good point Jasper, I may also look at using the heater matrix flow as that is the right side of the thermostat I think....Thanks for the advice really appreciated

Hi Jasper, its got two but one it useless as its so close to the distributor you can't fit a gnats cock in there (a term my old flying instructor used to use a lot, "Nose up a gnats cock me lad"

Morning all Ok so I need to feed 2 water temp sensors on my 302 as its running EFI. Don't really want to put one on the rad side of the thermostat as that would only give a reading when open, would cause issue if the thermostat failed a swell as I would not know. So I was thinking on my water...

Good lord that was a Renault design special !!!! Thanks will take on board and having a chat with Mick as I have a small list of questions, cheers all

Yes that about it, I put 3L in and it was under the mark will have a chat with Mick tomorrow got a list of questions building anyway

Cheers will do!!

Evening all Ok so filled my recon UN1 last night to just below the fill hole as I ran out of oil, that was 3L, popped up tonight to see a puddle of oil under the box, seems to be coming out from the drive shafts, worse on the passenger side, I assume UN1 is fill to plug level? If so then any...

Hi Jasper, got it from Mick at SGT it was made by this Tim aka http://www.autosportelectronics.co.uk/ Its a well made loom, some of the leads are too short which is a bit irritating but as you say well made.

Ok been a while and had the camera in the workshop tonight taking some photos of loom plugs so i van have some made up so... Had to move the coil pack, originally on the passenger side but it was in the way of the ECU loom, probably better on the driver side as closer to the ignition pack...

Different fan theme anyone remember this short foray!!

Cheers chaps under seems the way and angled, I'll see what best fits, really appreciated.

Hi all Not sure if this is engine or electrics but what the heck !! Plug cap angle to best miss the snakes....Straight, 90 or 135? Also best to loop up and over the rockers I guess? Real Steel recommend Moroso Blue Max spiral core Cheers

SOLD!!

Perfect let me know, cheers

Hi Got brand new unused (no box) 8579 I don't need as I needed a dual trigger one that is on its way from the USA https://www.holley.com/products/ignition/distributors/ford/parts/8579 Has a small scuff mark round the clamp ring apart from that is as new, have all the paperwork and spring...