Brett James-McCall
Moderator
Normally, I would go and do this, but I am snowed with work and looking after the baby.
I am trying to draw up some drive flang adaptors so I can use Granada CV Joints. I have the basics done. Where I am needing help is the difference in the offset between the sides from the centre line.
Can anyone help? Scott?
In advance, Thanks
Brett
I am trying to draw up some drive flang adaptors so I can use Granada CV Joints. I have the basics done. Where I am needing help is the difference in the offset between the sides from the centre line.
Can anyone help? Scott?
In advance, Thanks
Brett
