Hello guys, simple question that should have a simple answer..
I have an early pre-100 CAV GT, and i'm busy revamping the suspension front and back. All rod-ends were worn, some seized, rubbers tearing, etc.
Also the wishbones themselves have developed quite a bit of corrosion, so I stripped them for powdercoating.
Now: I want to take that oportunity to replace the ball joints with new, since some of them are corroded as well, but I can't figure out what make/model they are off of.
Is there anyone that has the answer? I saw an older post claiming they are BMW E30's, but according to my spare shop's books, the taper on those is quite different and is not the same thread size.
Hope this body of knowledge can answer this simple question
thanks, Jasper
I have an early pre-100 CAV GT, and i'm busy revamping the suspension front and back. All rod-ends were worn, some seized, rubbers tearing, etc.
Also the wishbones themselves have developed quite a bit of corrosion, so I stripped them for powdercoating.
Now: I want to take that oportunity to replace the ball joints with new, since some of them are corroded as well, but I can't figure out what make/model they are off of.
Is there anyone that has the answer? I saw an older post claiming they are BMW E30's, but according to my spare shop's books, the taper on those is quite different and is not the same thread size.
Hope this body of knowledge can answer this simple question
thanks, Jasper