Half shafts

K

Kent

I`am looking for advice or recommendations on who to contact to have half shafts made for my GT40 build? I`m located in central Minnesota.
 
M

Morten

Mortified GT
Supporter
Which gearbox? Uprights? Bolt pattern pcd for CV joints 100 or 108?
Length from gearbox flange to upright flange?

Morten
 
manta22

Neil

Supporter
I have a set of Summers Brothers Unobtanium Porsche axles that I did not use. I can measure them if you're interested.
 
K

Kent

manta22 said:
I have a set of Summers Brothers Unobtanium Porsche axles that I did not use. I can measure them if you're interested.
Click to expand...
Thank you Neil I will be in touch with you this coming weekend I'm out of town working rite now when I get back I will get some measurements and contact you.
 
manta22

Neil

Supporter
OK, I'll put these on the market:

Here are photos of these axles. They are forged 4340 made by Summers Brothers for a Porsche. I don't remember which model Porsche it was ( I think it was a 934 or 936?) but he said that they were spares for Daytona. The splines are 31mm dia, 28 splines, and the length s are 17 5/8" end to end. These are a pair, of course. Offers?


Attachments

 
You must log in or register to reply here.

Similar threads

H
930 CV Joint and 36 Spline?
Replies
6
Views
666
Howard Jones
Howard Jones
M
GT40 Scratch Build Chassis
Replies
4
Views
681
Turbo-T
T
C
New Member, Central Ohio
Replies
6
Views
333
nvoort
N
J
Driveshaft phasing with CV joints
Replies
5
Views
1K
beeman
B
S
GT40 Rear Clip for Sale
Replies
3
Views
524
Scott13
S
Back
Top