I have a pair of 15X9 Halibrands with 2.5 backspace with Lola and Halibrand marked on them. Can anyone help me identify what these were designed for?
Thank you !
Thank you !
Lola wheels
- Thread starter flatheadjunk
- Start date
Only Picture I have seen of a Lola with Halibrands. Donahue in a T70 Spyder
Cheers
Fred W
B
Cheers
Fred W
The wheels I have are the same as shown on the Donahue car.They are 6 pin w/Halibrand knock off's.
Thanks for the info
Thanks for the info
You have a photo of the rear side of the wheels? Looks like some wheels I have that is 10" and 14" wide. They have holes for 6 pins on the rear. I'm in need of adapters for these.
Here is the front, and rear view of the wheels.
Four of mine are 4 pin, and one is 6 pin.
Center hole is 2 1/2".
Not sure that this how you do it But........
I had some one tell me that if I wanted to change the placement of the pin holes,
to thread the existing hole's, and fill with a threaded aluminum rod so that it was flush.
And then re drill hole's to what I wanted.
You might check with some one who know's for sure before doing something like that !
Hope the picture is of some help ?
Cheer's, Curtis
Four of mine are 4 pin, and one is 6 pin.
Center hole is 2 1/2".
Not sure that this how you do it But........
I had some one tell me that if I wanted to change the placement of the pin holes,
to thread the existing hole's, and fill with a threaded aluminum rod so that it was flush.
And then re drill hole's to what I wanted.
You might check with some one who know's for sure before doing something like that !
Hope the picture is of some help ?
Cheer's, Curtis
Attachments
Yes they are magnesium,
and there is a bit of surface corrosion.
Not sure if that makes any difference as he just wanted to see the inside of the wheels to compare with his.
I don't think that plugging the hole's, and re drilling is a good plan either.
Just passing along what I was told,
with the prompting to check with some one that knows what their talking about.
Cheer's, Curtis
and there is a bit of surface corrosion.
Not sure if that makes any difference as he just wanted to see the inside of the wheels to compare with his.
I don't think that plugging the hole's, and re drilling is a good plan either.
Just passing along what I was told,
with the prompting to check with some one that knows what their talking about.
Cheer's, Curtis
