Reproduction GT40 Bellhousing

[Richard]

I'm looking to buy a reproduction GT40 bellhousing. I think the part is good but the person says it takes a stock GT40 starter and small flywheel and clutch. My question is where do I get a GT40 starter, clutch and flywheel. I've seen pictures of GT40 starters and they look like any other ford starter from the 60's but the clutch and flywheel are a big ???. Thanks for the help. [/font]

 

[JimmyMac]

Try Safir. Bob can supply the whole package for you.
You seem unsure regarding the suitability of your bellhousing.
What model of ZF transaxle are you using ? Is your bellhousing flange a 4 bolt or 6/7 fitting ?
The starter and flywheel are different to common US Ford production parts. There are also internally balanced flywheels available.
The splined shaft on the ZFs and RBTs also vary in diameter and this will also determine your choice of clutch.

 

[Richard]

Thanks for asking about the 4/6/7 bolt hole issue as the part I was looking at has only 4 bolt holes which I don't think would work. I'm going to be using the new ZFQ. Thanks again.