ZF -1 Throwout Bearing
- Thread starter PETER HILL
- Start date
Ole Nylende
Supporter
Do you have a clutch "100% to the original spec" or some aftermarket part?
You need to start with the clutch vendor, drawing or similar to get the correct dimensions for your bearing...
You need to start with the clutch vendor, drawing or similar to get the correct dimensions for your bearing...
Yes original spec
Typo correction 7.25".
Sorry for the confusion.
Ole Nylende
Supporter
There was a print included in the gt40 uncovered book.
The clutch shown there is a twin disc borg & beck (AP?)
It is denoted that a SKF 400943 release bearing is recommended (maybe the same as a std pantera bearing?)
And an adaptor with a contact "ring" of 2,06" dia with 0,09" radius.
Might not help anything at all...
The clutch shown there is a twin disc borg & beck (AP?)
It is denoted that a SKF 400943 release bearing is recommended (maybe the same as a std pantera bearing?)
And an adaptor with a contact "ring" of 2,06" dia with 0,09" radius.
Might not help anything at all...
Lee Patterson
Supporter
The Safir dual disc clutch uses the Pantera TO bearing. Here is the McLeod part. The bearing comes apart and can be machined down depending upon the application based on the gap / free play you have when the stack is assembled. Don't know if this helps or not.
www.summitracing.com
McLeod Racing 16525 McLeod Throwout Bearings | Summit Racing
Free Shipping - McLeod Throwout Bearings with qualifying orders of $109. Shop Throwout Bearings at Summit Racing.
