1. Alan L

    Alan's RCR40

    In January I took delivery from RCR of my “Turn Key Minus” RCR40. I had every intention of posting sooner, but the build, work, and life got in the way. Car is a Mk1, right hand drive with 2” flares. Engine is a carbureted, aluminum block, Keith Craft 342 (302 based) that will be mated to a...
  2. C

    Bear claw - 1 click or 2?

    In Allan's video of his bear claw installation he states the mechanism only latches until the first click. Is there a reason why it won't engage to the second click? I'm getting ready to locate and install my striker pin and want to be sure I don't install it in the wrong place if there's...
  3. A

    MK I roof vent

    I have a GTD-40 and want to install a roof vent where can I find one? Thanks
  4. Dave Hood

    FAST 2.0 EFI Install

    A few weeks back I had Paul Whitlock (here in Charlotte) swap out my old Pantera fuel injection system with the FAST 2.0 self-learning unit. The install was a bit tricky since I'm running an Eight Stack EFI system that draws so much air. But Paul did an amazing job getting it right. Along...
  5. T

    Aluminator 5.2 XS

    Has anyone tried to install the new Ford Aluminator 5.2 XS? I am wondering how difficult it would be to mate up to the Graziano gearbox and install in the GT-R?
  6. M

    Install rivnuts before painting?

    Hello, Hopefully some advice on the best sequence. I want to understand this before I do something less than optimal. Example, suppose I am making the side windows removable and using rivnut inserts to facilitate that. Would I install the rivnuts now and verify proper alignment and...
  7. V

    how to remove inner trans axle hub on zf trans

    Trying to re install axle with new boots and need advice on easiest way to install it. I have full axle assembly out I just cant put it back in without the bearings falling out... advice would be appreciated.
  8. C

    ECU Recommendations

    Hello folks, What in opinion is the best ecu for the LS series engines that will also maybe run the SBF engines as well? Is it better to take the car and have someone install the ecu for a cleaner look or it one of those installs with a little patience can be accomplished without many issues...
  9. L

    Install question

    On average, how long does it take an experienced gearhead to physically install an engine and transaxle in a GT40 and hook up all the prerequisite control cables, hoses, blah, blah, blah? (Tuning and all that 'after-the-fact' stuff aside.) I have $10 USD riding on the answer! 'No pressure...
  10. Mark IV

    SPF Drivetrain Install

    Once upon a time there was an online "wiki" with much of the information. Sadly the person who hosted it has let it go. If we can recover the documentation I will host it in the future. You are welcome to call Time Machines and we will help however we can. And perhaps ypu will need some of...