Coyote Intake Manifold Reversal?

Probably a long shot here, but is the Coyote intake manifold reversible? Can you flip it so the throttle body is pointing towards the flywheel?
 
Check out--Rentos GT-Forte GT40 Coyote Thread-than go to page 3.
There are pictures showing the procedure. Good luck ,I am doing the same thing.
 
i was looking at this a while back.

there are adaptor plates to go from mod to coyote upper
Manifold

5.4%20to%20coyote%20adapters.jpg


5.4%20to%20coyote%20adapters%20installed.jpg


5.4%20to%20coyote%20adpaters%20installed%202.jpg


so presume you could also get a plate made to go from coyote to mod, which would be handy as things like this are available for the mod
126427-500-0.jpg


which would allow a standard air cleaner arrangement to be installed on the rear deck and go through the body work with out needing any modification.

Ryan
 
I did the same using a Cobra Jet intake. Just need to extend a wire and grind ever so slightly to remove a bit of material.
 

Attachments

  • 20150508_143636small.jpg
    20150508_143636small.jpg
    124.7 KB · Views: 504
If it is him, what's going on in that bottom video!?

I will have a guessing they are checking/tuning for fuel reversion or stand of in the individual throttle bodies. adjusting the tune for very quick and clean throttle response. it certainly sounds very instantaneous and I can't see a cloud of fuel vapour coming back out the top of the trumpets.

Regards Ryan
 
Back
Top