Extra air in - scoops.

[Aussie Kid]

Thanks for the links.

I have lined the rear clip with thermal blanket and I have re painted as the paint was in need of some touch ups etc.

I have fully rewired, re trimmed re built the engine and trans, up graded the brakes etc..etc. as a lot on the car was built on a tight budget when built. I always wanted to drive it for a while and then rebuild.

 

[Aussie Kid]

I want to run the scoops to get some more air flow into the engine compartment. I will also run two Perspex scoops on rear window. Again to just get air in. I have been running K N type foam filters and the tune is seeing a very rich run. So I am also doing away with the filters and using the T strainers !!

Again thanks for the links and information.

 

[Donald Ashworth]

Hello Everyone. I am looking to purchase but would prefer to fabricate (3D print a plug, make a mold, pull the fiberglass product) a set of 1966 GT40 MK2 rear periscope air intakes. Any advice on this topic? This is for me alone, and if I find a 3D model, you have word I would be building these out for me alone.

Many thanks,
Don

 

[Davidmgbv8]

Hello Everyone. I am looking to purchase but would prefer to fabricate (3D print a plug, make a mold, pull the fiberglass product) a set of 1966 GT40 MK2 rear periscope air intakes. Any advice on this topic? This is for me alone, and if I find a 3D model, you have word I would be building these out for me alone.

Many thanks,
Don

Call Bill Hough, he has molds and makes them reasonably. 781-659-1404 [email protected]

 

[Ole Nylende]

Hello Everyone. I am looking to purchase but would prefer to fabricate (3D print a plug, make a mold, pull the fiberglass product) a set of 1966 GT40 MK2 rear periscope air intakes. Any advice on this topic? This is for me alone, and if I find a 3D model, you have word I would be building these out for me alone.

Many thanks,
Don

Drop me your email in a pm and i can forward a model for you