G50 pilot shaft

[Mike Blair]

Bear with me on this as I am new to this. My previous post on the pilot bearing was not what I actually needed.
I am looking for the outer diameter of the pilot shaft of the porsche G50 transaxel. My engine guy is requesting this.
I plan use a G50 mounted to a modified Jaguar V12 for my RCR XJ13.
6.8 liters 13:1 CR TMW throttle bodies. I will expect I will enjoy listening to it almost as much driving it.

 

[Doc Kaler]

The G50 has a pilot shaft diameter of 14.9mm, 23 splines, outer spline diameter of 25.4mm.

You can get the clutch alignment tool from Pelican Parts.

 

[Mike Blair]

Thanks Doc

 

[Erik]

Hi Doc.

 

[Doc Kaler]

Hi Erik,

My G50.50 found a good home in Australia. Maybe you can start specializing in Ricardo rebuilds? :thumbsup: