Rob Klein
Supporter
i will take whats in stock
GT 40 "Tulip" walnut shift knobs with emblem
- Thread starter Mark IV
- Start date
Put me down for a walnut one for. LHD SPF. Thanks!
OK,
PM me
PM me
We are back up and running. The first of the limited supply Brazilian Rosewood knobs are off the lathe and ready for thread inserts. We have M8-1.25, M10-1.25, M10-1.50 and 1/2"-20 inserts on hand. Other sizes by special order.
The walnut knobs are $95.00 and the Rosewood are $119.00 plus shipping. They are finished with a heat activated finish that is very resistant to body oils and makes a nice gloss finish. These include the "GT40" enamel insert. No insert knobs are available as well by order. We can also supply custom knob sizes. Our standard knob is based on the FAV knob but we do them about 1/4" taller as most seem like the fit to hand better. We can supply FAV dimensions at no extra cost. PayPal or credit cards are accepted. PM or email [email protected]
The walnut knobs are $95.00 and the Rosewood are $119.00 plus shipping. They are finished with a heat activated finish that is very resistant to body oils and makes a nice gloss finish. These include the "GT40" enamel insert. No insert knobs are available as well by order. We can also supply custom knob sizes. Our standard knob is based on the FAV knob but we do them about 1/4" taller as most seem like the fit to hand better. We can supply FAV dimensions at no extra cost. PayPal or credit cards are accepted. PM or email [email protected]
Attachments
Last edited:
I take the Rosewood in M10x1.25
PM sent
PM sent
RICK MAKES A VERY NICE SHIFT KNOB
Just shipped 11 knobs to the UK for a group purchase. Please note I will out of the office/shop/factory/kindergarten for the month of April so shipments will be delayed.
Thanks,
Walt, your check is in the mail!
