Did a little searching around and not finding anything specific or of great quality but I think I've seen some on this site. Do you guys have any suggestions/solutions for grommets for shift cables through the bulkhead?
Shift cable grommet for bulkhead
- Thread starter LBCportagee
- Start date
I think I've seen some using this style. what size or part number have you guys used (and is this recomended?)
I did not use any. My bulkhead seals to the tank around the hole through the tank, then I stuffed foam rubber in the hole around the shift cables.
But, these are all good options:
Split Bulkhead pass-through
Solid Bulkhead pass-through
Plastic Cord Grips
Aluminum Cord Grips
Note the cord grips are available in a number of different body sizes and have different rubber inserts for different cable sizes. I've ordered 100s of the AL Cord Grips from elecDirect.com and have been happy with them (for work projects).
But, these are all good options:
Split Bulkhead pass-through
Solid Bulkhead pass-through
Plastic Cord Grips
Aluminum Cord Grips
Note the cord grips are available in a number of different body sizes and have different rubber inserts for different cable sizes. I've ordered 100s of the AL Cord Grips from elecDirect.com and have been happy with them (for work projects).
Thanks for the information. One of these will certainly work. I am about to start that part of the project.
