Maybe this has been covered before, but...
When I was drilling holes for the door hinges, I noticed my bit had slid to the left a bit. This upset me greatly. I had whacked the spot with a punch, then carefully started the hole, but still ended up drifting to the left about 1-2mm. Should I be using a better/different bit? Any suggestions here, I'm really upset with myself.
When I was drilling holes for the door hinges, I noticed my bit had slid to the left a bit. This upset me greatly. I had whacked the spot with a punch, then carefully started the hole, but still ended up drifting to the left about 1-2mm. Should I be using a better/different bit? Any suggestions here, I'm really upset with myself.