Search results

I've noticed some people have used dzus fasteners near where the front clip meets the bottom of the spider. Could someone let me know if this is necessary and what the purpose is for?

The rear clip on my RCR 40 will not open fully, it only makes it about 2/3rds of the way before it interferes with the circled area in the photo. I haven’t put the tires on yet but it’s my guess that it would hit those as well. Is the circled area supposed to be trimmed in some manner before...

I'm looking for some guidance on what others have paid for their paint and body work on their RCR vehicle. I'm especially looking for information from those in the Houston or Dallas areas. I have an RCR 40 and I'm getting really close to paint time, I just want to know what to expect...

Can anybody point me in the right direction on where to find some of these fog lights?

Well it's been about a year since I received my car from RCR, and I've finally had time to start a build log. Over the course of the last year I've gotten a lot accomplished and have always chosen to use the time I have available to work on the car rather then doing a log. Now I'm getting to a...

For those that opted to use a hydraulic throw out bearing with their ZF, where did you route the top bleed line through? Did you drill a hole in the bellhousing or trans case above where the shift linkage would normally be? The bottom line can obviously run through the shift linkage hole but...

Just curious if anyone has had to trim the bottom of the dash where it contacts the sponsons on the RCR 40 to achieve the level the dash should be at with the doors. I might be right where I need to be without trimming but it's hard to tell from other's photos. Most of the photos I'm able to...

I'm looking for some help on my fuel pickup tubes. I bought the tanks inc. pickup tubes that are 3/8 NPT( http://www.tanksinc.com/index.cfm/page/ptype=product/product_id=94/category_id=167/mode=prod/prd94.htm) and put in 1/2 to 3/8 NPT Fragola reducers. Unfortunately, it is about a 1/2 inch...

Well I figured that it's about time to finally do an intro thread as I recently took delivery of my RCR 40. I'm located in Bryan, Texas and this will be my second build (third if you count a motorcycle I did). I started looking through this forum after finishing my Factory Five Cobra build in...

What thickness of aluminum stock is typically used to fabricate removable switch panels on the dash?

I need some help in regards to selecting my clutch, flywheel, and bellhousing... As of right now I'm leaning towards getting a bellhousing from Kennedy Engineering (SBF 302 to RBT ZF) but I'm also considering Quicktime because I've used them before. My motor is from Craft Performance...