pump

I’m in the process of consolidating my shop to get ready for a cross-country move. Many things need to find suitable homes. Offered here is a collection of various SW240a fuel pumps, gaskets and assorted parts.. There are eight pumps in total. All have some external corrosion to varying...

Hi all I am looking at fitting a pump to my servos . Mine just don't feel like they are working properly . Have to press pedal quite hard . My question is has any body fitted an electric servo pump and any for or against .. Thanks all .. John.

Caution, I have installed Painless kit #10144 . I had to modify it to stop the chance of 40 amps in a 16 g wire. A test also over heated the output 16 g wire from the relay I was about to use for a fuel pump. the kit was a big waste of money and wouldn't like to see anybody go up in smoke.

Hi: I am in the process of ordering the Quaife transmission for a Superformance GT40MKII that I have under construction. The car has the optional transmission oil cooler, and I am wondering whether anyone has ordered the oil pump from Quaife (which I believe is mechanical) or has used an...

-SOLD- Mallory Pro Comp Series 140 Fuel Pump I have a new Mallory Pro Comp Series 140 Fuel Pump, new, still sealed in the bag. Part # 29259, 140 gph, 12 psi max, 3/8 NPT From Summit: Mallory Comp Pump Fuel Pumps 29259 - Free Shipping on Orders Over $99 at Summit Racing These Comp Pump...

Hi all I have a new Holley 600 . been on my engine about 6 months . not used it much . Still waiting for IVA . my question is the pump diaphragm has been leaking . I replaced it yesterday and its still leaking . Should I put a sealant on it ? I know it came without sealant . I will get in...

A few weeks back I had Paul Whitlock (here in Charlotte) swap out my old Pantera fuel injection system with the FAST 2.0 self-learning unit. The install was a bit tricky since I'm running an Eight Stack EFI system that draws so much air. But Paul did an amazing job getting it right. Along...

It seems like the water flow on my cooling system is opposite of what I want it to be. I want the flow to exit thru the t-stat and go to the high side of the radiator on the passenger side and return thru the low side of the radiator on the drivers side. Just warmed the engine up to full...

Delete Delete.

Hi All, I am having an engine built by Chris Smith at Devon Racing and was hoping that someone may have experience with an engine to a similar specification. Does the specification look like a good combination of components and how much BHP and torque might the engine make? Induction system is...

Currently have a ford 342 by roush with a 750 cfm. holly . The ignition is MSD electronic. I am tempted with the borla 8 stack efi Webber look like so being OCD about understanding the system before buying it wondered if I could get some corrective advice on the workings of the system. 1 ...

I've read several threads about fuel systems, pumps, swirl pots, baffling, etc. I'm currently running a single mechanical (Carter) pump to the Holley carb on my Roush 427SR. Both the pump and Holley were supplied with the crate engine. My symptom is that the engine has died twice recently...

When I purchased my car secondhand it came with a set of well made stainless steel tubes from the engine to the radiator. Now that I'm at the point of finalizing the cooling system I realized the tubes are backwards. The radiator outlet is at the top of the rad. The issue being any steam/ gases...