016 vs 01E

[Christo]

What is the best between the 2, I have a 016. Is the bolt pattern the same between the 2. I have a gilo adapter plate, but it's for the windsor motor. I will be using it on a coyote so will need to do a new adaptor plus flywheel. Just need to know is it worth it to use the 016 or must I look at the 01E

 

[Jim Dewar]

016 bearings are not available worldwide, I discarded 3 016 boxes and changed to 01E.

 

[Christo]

Thank you Jim, so with that being said looks like I have a massive paper weight. Do you maybe know if the bolt pattern between 016 and 01E is the same

 

[Jim Dewar]

Thank you Jim, so with that being said looks like I have a massive paper weight. Do you maybe know if the bolt pattern between 016 and 01E is the same

Mine wouldn’t work, ordered a new setup from Kennedy engineering.

 

[Randy V]

016 bearings are not available worldwide, I discarded 3 016 boxes and changed to 01E.

Did you try contacting a bearing house directly with the numbers and measurements from your bearings?
I have done this successfully numerous times in the past - but it has been a number of years…
You might also check mcmaster.com

 

[Jim Dewar]

Did you try contacting a bearing house directly with the numbers and measurements from your bearings?
I have done this successfully numerous times in the past - but it has been a number of years…
You might also check mcmaster.com

Yes , I contacted the bearing distributors direct and pinion bearings are no longer manufactured. German transaxle in Washington state told me this and I went to European suppliers and received the same results.