Hi All,
Just reaching out to ask if anyone has any experience of Comp Cams... I understand they are owned by Edlebrock so am guessing a uality product but have heard on or two issues on other V8 Forums.
I am thinking problems are likely to be from wrong run in or oils thereafter but good to hear anyone's experiences.
I finally identified I lost lobs on my Edlebrook 7222 RPM Cam as a result of dual prings that were too stiff..... an expensive error... !!!
Whilst roller Cam would be a good option budget is a consideration and I am hoping that if I get the install run in and zinc oils correct then fingers crossed I will be good...
So after reaasearch I am looking at either a EX 262H or EX 268H for my new top end this time with matching Spring rates...!!!
I am running a 302 stroked to 347 with TrickFlow 1700 Ally Heads Edlebrock 650cfm 4barrel Carb and RPMAIRGAP manifold...
I am leaning toward the EX268H after reading reviews and welcome anyone's Comp Cam experience.
Just reaching out to ask if anyone has any experience of Comp Cams... I understand they are owned by Edlebrock so am guessing a uality product but have heard on or two issues on other V8 Forums.
I am thinking problems are likely to be from wrong run in or oils thereafter but good to hear anyone's experiences.
I finally identified I lost lobs on my Edlebrook 7222 RPM Cam as a result of dual prings that were too stiff..... an expensive error... !!!
Whilst roller Cam would be a good option budget is a consideration and I am hoping that if I get the install run in and zinc oils correct then fingers crossed I will be good...
So after reaasearch I am looking at either a EX 262H or EX 268H for my new top end this time with matching Spring rates...!!!
I am running a 302 stroked to 347 with TrickFlow 1700 Ally Heads Edlebrock 650cfm 4barrel Carb and RPMAIRGAP manifold...
I am leaning toward the EX268H after reading reviews and welcome anyone's Comp Cam experience.
Last edited: