Following on my issue selecting the correct door seal, (See 228 in build log), I’ve been looking at what is available. The current design has a 15mm sealing bulb and I can get a smaller one with a 13mm sealing bulb, but I concerned even this will be too large. In its uncompressed state, the current seal is flush with the out edge of the spider in places, so I don’t think that 2mm smaller will be sufficient.
<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com<img src=" /><o
></o>
Has anyone got any experience in using the following type of seal, as it look like it will compress more than a bulb seal?
<o></o>
Regards<o></o>
Andy<o></o>
<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com<img src=" /><o
></o>Has anyone got any experience in using the following type of seal, as it look like it will compress more than a bulb seal?
<o
></o> Regards<o
></o>Andy<o
></o>
