When running the Motec system as setup for an RF using the Ford Cam Sensor, how do you install the sensor? Having put the motor at TDC on #1, how do you set the Cam Sensor? Do you drop in the sensor then set the Sync in the software or do you set the sensor at a special point in relation to TDC, then fine tune in the software.
I have been trying to get my motor to run and have been getting a Sync Error. I am gettin spark but suspect that it is at the wrong time. The Motec software version 3.4 has a Sync/Ref capture feature that shows you the signel just as a scope would. This feature shows the square wave form from the Hall effect Sync sensor and the signal from the magnetic Ref sensor and the two do not line up. The Sync signal seems to run about seven pulses behind the missing tooth Ref signal.
Help.
Peter
I have been trying to get my motor to run and have been getting a Sync Error. I am gettin spark but suspect that it is at the wrong time. The Motec software version 3.4 has a Sync/Ref capture feature that shows you the signel just as a scope would. This feature shows the square wave form from the Hall effect Sync sensor and the signal from the magnetic Ref sensor and the two do not line up. The Sync signal seems to run about seven pulses behind the missing tooth Ref signal.
Help.
Peter