Ford 302 engine for sale. Engine block dated between 87 and 92 so not ideal for IVA purposes.
Removed from my GT40 replica and not run for more than a decade. Built by the original owner of the car in the early 90’s and has covered 8,100 miles only.
Engine has Dart big valve (steel) heads (+30% larger than standard valves) Chamber volume 64cc CR 9.7:1 stainless valves
Double valve springs
Screw in rocker studs
Reed camshaft (duration 272_282, 530 thou lift)
Crane chrome_moly pushrods
Magnum 1.6 roller tipped rockers and guideplates
TRW forged pistons, moly rings
Vernier timing gear
Rods lightened and balanced
High volume oil pump
TRW main and big end bearings
Engine has been partly dismantled for inspection.
Heads look perfect (heads off)
Bottom end also (sump off)
Bores also look good apart from some very slight water ‘staining” on a couple of bores.
Personally I would think they may hone up fine, But please recognise I am no expert and it may need a rebore (please come and inspect for yourself)
Original owner quoted 350 BHP for this engine.
Lots of pictures available on request.
Based in RM14 area east of London
£1995
Please drop me a PM with an email address for more pics/any further info.
for any further pics/info
Removed from my GT40 replica and not run for more than a decade. Built by the original owner of the car in the early 90’s and has covered 8,100 miles only.
Engine has Dart big valve (steel) heads (+30% larger than standard valves) Chamber volume 64cc CR 9.7:1 stainless valves
Double valve springs
Screw in rocker studs
Reed camshaft (duration 272_282, 530 thou lift)
Crane chrome_moly pushrods
Magnum 1.6 roller tipped rockers and guideplates
TRW forged pistons, moly rings
Vernier timing gear
Rods lightened and balanced
High volume oil pump
TRW main and big end bearings
Engine has been partly dismantled for inspection.
Heads look perfect (heads off)
Bottom end also (sump off)
Bores also look good apart from some very slight water ‘staining” on a couple of bores.
Personally I would think they may hone up fine, But please recognise I am no expert and it may need a rebore (please come and inspect for yourself)
Original owner quoted 350 BHP for this engine.
Lots of pictures available on request.
Based in RM14 area east of London
£1995
Please drop me a PM with an email address for more pics/any further info.
Last edited: