Ron Earp
Admin
Have a look at the picture below.
I'm coverting my motor over to drive a mechanical fuel pump. However, my two piece fuel pump cam has a locating tab that my cam gear does not have a provision for. I vaguely remember there was another another type of fuel pump cam, a single piece, but did it have a tab?
The round hole in the fuel pump cam goes allow the cam sporket retaining gear to be bolted to the cam. That square notch (bad angle) is a punch out that is actually a tab, the tab is just facing you so you can't see it.
Looking for a solution around this issue. Any you fellows encounter anything similar?
Ron
I'm coverting my motor over to drive a mechanical fuel pump. However, my two piece fuel pump cam has a locating tab that my cam gear does not have a provision for. I vaguely remember there was another another type of fuel pump cam, a single piece, but did it have a tab?
The round hole in the fuel pump cam goes allow the cam sporket retaining gear to be bolted to the cam. That square notch (bad angle) is a punch out that is actually a tab, the tab is just facing you so you can't see it.
Looking for a solution around this issue. Any you fellows encounter anything similar?
Ron