Hi all,
I am sure I've seen some of these dimensions on previous poosts, but thought it might be handy to have them all in one place.
What I'd like to know are the following dimensions:
- input shaft diameter,
- input shaft length,
- driveshaft centreline below input shaft,
- distance from face of gearbox to driveshaft centreline
for the following boxes at least:
ZF 5DS 25,
LG600,
T44,
Porsche 930,
Porsche G50 (I assume 50 & 52 are the same),
Audi 016,
Audi 01E,
Renault UN1.
Either post them here, or add a link to the relevant thread.
I'm hoping this might help some of us establish what likely alterations might be required for each option (e.g. inclined driveshafts, engine mounted further forward/lower),
or when considering swapping from one to another.
Cheers,
John.
p.s. I'm personally interested in the dimensions for the LG600, T44, ZF, and G50/52. /ubbthreads/images/graemlins/wink.gif
I am sure I've seen some of these dimensions on previous poosts, but thought it might be handy to have them all in one place.
What I'd like to know are the following dimensions:
- input shaft diameter,
- input shaft length,
- driveshaft centreline below input shaft,
- distance from face of gearbox to driveshaft centreline
for the following boxes at least:
ZF 5DS 25,
LG600,
T44,
Porsche 930,
Porsche G50 (I assume 50 & 52 are the same),
Audi 016,
Audi 01E,
Renault UN1.
Either post them here, or add a link to the relevant thread.
I'm hoping this might help some of us establish what likely alterations might be required for each option (e.g. inclined driveshafts, engine mounted further forward/lower),
or when considering swapping from one to another.
Cheers,
John.
p.s. I'm personally interested in the dimensions for the LG600, T44, ZF, and G50/52. /ubbthreads/images/graemlins/wink.gif