Davidmgbv8
Supporter
So now I have my front spindles back and wheel mounted the front hits the fender on turns. The front tyre is 215/60-15. Placing the front clam forward to where the opening is almost centered and allows the wheels to turn gives me a 1” spyder gap. Wheel base is precisely 95” or 2413 mm. Sills are butted up against chassis at rear. Rear wheel centered in opening, car sitting with lower A arms level.
Need advice and suggestions please. Front clam molded off of 1017 and rear off of 1054, spyder molded off steel unit and is 2 5/16” wide above scoop.
Thanks for opinions and help.
Need advice and suggestions please. Front clam molded off of 1017 and rear off of 1054, spyder molded off steel unit and is 2 5/16” wide above scoop.
Thanks for opinions and help.