Chet Zerlin
Supporter
Hi all,
I'm at the point of assembly where I'm beginning to drill out the openings in my dash and I started with the holes for the AC vents. However after cutting them out and placing the dash back on the car it looks to me that my dash is sitting too high. The top of the hole sits about 1" above the top of the chassis. I'm also including a side shot of the dash as it is fitted to the chassis to show its height against the chassis.
Any assistance in understanding what is needed to make this fit (and how the AC from the plenum is supposed to be mated to the AC vent that goes into that hole) would be greatly appreciated. Do I need to trim the bottom of the sides of the dash to get it to fit lower on the chassis or is it in the correct position?
Thanks in advance for your help!
Chet
I'm at the point of assembly where I'm beginning to drill out the openings in my dash and I started with the holes for the AC vents. However after cutting them out and placing the dash back on the car it looks to me that my dash is sitting too high. The top of the hole sits about 1" above the top of the chassis. I'm also including a side shot of the dash as it is fitted to the chassis to show its height against the chassis.
Any assistance in understanding what is needed to make this fit (and how the AC from the plenum is supposed to be mated to the AC vent that goes into that hole) would be greatly appreciated. Do I need to trim the bottom of the sides of the dash to get it to fit lower on the chassis or is it in the correct position?
Thanks in advance for your help!
Chet