Hello
Just started to fix my hard brake lines to the chassis running from front to back, I thought I would use these Stainless Steel self tappers but I have had two where the thread has gone either installing or removing and when thread goes they are very difficult to remove
I've tried a slightly bigger drill but then they are too loose
They just dont seem very strong
I can't go much bigger as these are going in a double pipe clip in the centre
Is Stainless just to soft?
Any suggestions please for UK Type and Source?
Thank you
Just started to fix my hard brake lines to the chassis running from front to back, I thought I would use these Stainless Steel self tappers but I have had two where the thread has gone either installing or removing and when thread goes they are very difficult to remove
I've tried a slightly bigger drill but then they are too loose
They just dont seem very strong
I can't go much bigger as these are going in a double pipe clip in the centre
Is Stainless just to soft?
Any suggestions please for UK Type and Source?
Thank you