un1 cv flanges

[Mike]

I am using a UN1-13 in a build and want to use 100mm cv's rather than the usual 108mm 930 cv's because I don't have room for the 108mm cv's on the outboard end. My info is that the Ford Granada flange from GT racing and the Delorean flange both go to the 108mm 930 cv.
Is there a flange available that fits the UN1 output stub axle but goes to a 100mm cv like the vw bus?
Thanks in advance for your help
Mike

 

[Jon Briggs]

Could try these:
DRIVE SHAFT ADAPTERS RENAULT/FORD - DSA

 

[Andy Sheldon]

Mike

We have what you need.

Email me at [email protected]

Thanks

Andy