It's nice to be able to report when a vendor goes out of their way for you. Just for kicks, I asked TWM Induction if they would consider making me a template for a turkey pan,
to fit my manifold. Within 6 hours, I received a complete
engineer's drawing, detailing every intake port, bolt hole, etc., down to the thousandth. I assumed that this was a
"stock" drwaing, until I saw that it was drawn for me specifically, that very same day! THAT is good service!
I'm getting a price today, to CNC cut the baseplate, and weld up the turkey pan. If it doesn't break the already broken bank, I'll post a photo, when it's done.
Also worth noting:
Although I did have more than my share of problems with my SDS EFI system, and am now going the MOTEC route, SDS was willing to take the system back, and fully refund my money. When was the last time somebody accepted the return of a slightly used electrical part? Not in my lifetime!
Bill
to fit my manifold. Within 6 hours, I received a complete
engineer's drawing, detailing every intake port, bolt hole, etc., down to the thousandth. I assumed that this was a
"stock" drwaing, until I saw that it was drawn for me specifically, that very same day! THAT is good service!
I'm getting a price today, to CNC cut the baseplate, and weld up the turkey pan. If it doesn't break the already broken bank, I'll post a photo, when it's done.
Also worth noting:
Although I did have more than my share of problems with my SDS EFI system, and am now going the MOTEC route, SDS was willing to take the system back, and fully refund my money. When was the last time somebody accepted the return of a slightly used electrical part? Not in my lifetime!
Bill
