Webber IDA Inlet Manifold

[Ron Rowse]

Dear Members.
I have an Inlet Manifold that I would like to sell to a good home rather than sell it on EBAY.

The Manifold is for a 427 side oiler. I have owned it since 1969. it came with a mountain of parts that I bought from S&S in Phoenix Arizona in the late 60s early 70s.

I am moving county. So I am going to sell all the engines and parts I have collected over the past 37 years.

photos below. Please feel free to contact me about this manifold.

Ron Rowse.

 

[Randy]

Is that an intake for a 302 I see on the table, Is it for sale?
Thanks
Randy

 

[Jac Mac]

Ron,
These photos are of a Holden 308 Manifold going by the port spacing/bolt pattern & the relief for the dist at one end in the valley area. If you bought them in the USA then they probably came from the Pontiac motor that the Holden V8 was derived from.

Jac Mac