Michel
Fit of the pedals is not an issue. I will fabricate individual support brackets for each pedal. The clutch pedal will fit nicely to the left of the steering column with enough room for a dead pedal. The brake will fit nicely to the right of the steering column, and there will be room for the gas pedal as well. All will clear the square steel tube frame member, similar to the set up on the original as seen in the photo posted previously.
I am attaching dimensions of the pedal arm. Not the pedal surface is off set 2" from the line connecting the MC connection and the mounting pivot point.
My plan is to locate the mounting bolt centered 5/8" to 3/4" below the undersurface of the top of the foot box. This will place the MC connection center point about 1 1/8" to 1 1/4"above the surface of the foot box, which will connect nicely to the master cylinder.
Hopefully this helps
Fit of the pedals is not an issue. I will fabricate individual support brackets for each pedal. The clutch pedal will fit nicely to the left of the steering column with enough room for a dead pedal. The brake will fit nicely to the right of the steering column, and there will be room for the gas pedal as well. All will clear the square steel tube frame member, similar to the set up on the original as seen in the photo posted previously.
I am attaching dimensions of the pedal arm. Not the pedal surface is off set 2" from the line connecting the MC connection and the mounting pivot point.
My plan is to locate the mounting bolt centered 5/8" to 3/4" below the undersurface of the top of the foot box. This will place the MC connection center point about 1 1/8" to 1 1/4"above the surface of the foot box, which will connect nicely to the master cylinder.
Hopefully this helps