At present the heater feed is taken off the thermostat near the water pump and both the feed and return hoses are taken down the central tunnel, I want to remove these two hoses and tee-off to the heater from the rad hoses in the front bay, for both feed and return. I am getting some ally Y joints made (rather than tee joints) to keep the pressure up for the heater. Question, does anyone know what I should do with the heater hoses on the engine, see image. You can see:-
Thermostat top-middle.
Heater feed 16mm hose on the left.
Heater return on the right, which has a tee to the water reservoir.
Do I just loop the heater feed from the t/stat to the heater return and close off the connection (heater) on the water tank?
Thanks in advance. K
Thermostat top-middle.
Heater feed 16mm hose on the left.
Heater return on the right, which has a tee to the water reservoir.
Do I just loop the heater feed from the t/stat to the heater return and close off the connection (heater) on the water tank?
Thanks in advance. K