Ken Roberts
Supporter
I bought longer DSS axle shafts due to converting to C6 hubs. I’m having trouble getting the c-clips installed once the star gears are slid on to the splined ends. When I disassembled the cv joints I noticed the star gear on one end of the driveshaft had the raised shoulder facing in and on the opposite end it was facing out. I can’t get the c-clip to drop in the machined groove on one end. The star gear will not slide on the splines far enough to expose the c-clip groove on the back side. (The picture shows my pencil tip resting on the shoulder) (notice the counterbore on the star pictured on the right side, all four have identical features) Any guidance would be appreciated.
Last edited: