The GM wiring harness manual indicates that a 5000 ohm- 1/4 watt resistor is needed for the RPM signal.
What I've done is soldered a 4700, followed by three 100's. The four soldered together makes for a rather long chain. Is there a better way to do this, and how should I go about protecting the resistors from being bent?
(LS376/Koso dash)
What I've done is soldered a 4700, followed by three 100's. The four soldered together makes for a rather long chain. Is there a better way to do this, and how should I go about protecting the resistors from being bent?
(LS376/Koso dash)