I've just gone through another clutch and I need to address this problem once and for all. The clutches which I have been using are said to be rated at 800hp to 1,000hp (which I think is bulls##t) and no mention of their torque rating.
What I'm looking at is going to a twin or tripple Tilton carbon/carbon clutch which will hold the torque and be easier to drive than a sintered multiplate clutch. I'm a little concerned going to the tripple carbon as there might not be enough room on the input shaft on the Audi 01E box. Has anyone got any experience with these clutches or have used them on an 01E.
Also I need a recomendation of where I can get these clutches from.
The part # I'm looking at are 6572USGGG-S12 for the twin, or 6573HGG-S12 for the tripple.
Looks like a new flywheel will need to be made as well.
Thanks in advance
Bob
What I'm looking at is going to a twin or tripple Tilton carbon/carbon clutch which will hold the torque and be easier to drive than a sintered multiplate clutch. I'm a little concerned going to the tripple carbon as there might not be enough room on the input shaft on the Audi 01E box. Has anyone got any experience with these clutches or have used them on an 01E.
Also I need a recomendation of where I can get these clutches from.
The part # I'm looking at are 6572USGGG-S12 for the twin, or 6573HGG-S12 for the tripple.
Looks like a new flywheel will need to be made as well.
Thanks in advance
Bob