Hi guys. I'm looking for ideas and experiences with finishing the interior half of a Gurney bubble. Since mine is a street car, I can;t really leave it in its current configuration - see pictures.
I opted to fasten it to the roof with (6-32) screws, because I like that look on the original cars and because I didn't want to fiberglass it in. I'm thinking about releiving the inside fiberglass a bit for a little more head room and glassing over the gap between the inside and outside roof panel. Before I can glass that gap in, ouf course, I'll neet to fasten #6 nut - probably epoxy them to the bottom side of the outer roof panel but I'm open to alternative ideas.
I opted to fasten it to the roof with (6-32) screws, because I like that look on the original cars and because I didn't want to fiberglass it in. I'm thinking about releiving the inside fiberglass a bit for a little more head room and glassing over the gap between the inside and outside roof panel. Before I can glass that gap in, ouf course, I'll neet to fasten #6 nut - probably epoxy them to the bottom side of the outer roof panel but I'm open to alternative ideas.