Afternoon all, Has anyone lengthened a Titan rack? I have moved my rack up out of the way of my shins by a small margin and as such the rack end ball centers are just a smidgin too short, 5mm each side so a total of 1cm. I did think to get some longer screw cups machined up and some longer nylon sprung spacers, which I am sure would work but maybe not the best solution. I have yet to take the rack apart to see the gubbins inside, I assume there is a solid bar with the pinion teeth cut into it in the centre and then a tube either side, screwed or welded on. Just thought I'd ask here and see if anyone has done something like this.
The other alternative would be to get another bar machined up by Titan with the correct ball centre to ball centre length.
regards Chris
The other alternative would be to get another bar machined up by Titan with the correct ball centre to ball centre length.
regards Chris