Bill Kearley
Supporter
I'v been watching the progress and love it, Nice work.
Some day I will be able to apply these learnings to completion of my RCR D.Body Alignment, Part I
With the drivetrain still setting in the chassis it was time to check body fit and alignment. To do so the tires need to be in place and the D Type sitting at its expected ride height. The rear suspension was temporarily assembled.
View attachment 100750
Some rear section design work was started before the body was set in place. A mock-up of the fuel tank and supports was made from foam core board to check fitment – it being much easier to work with light foam core board then heavy metal pieces. More measurements and design work remain. We plan to fabricate a steel sub frame to support the fuel tank and some other items.
View attachment 100751
View attachment 100752
The front suspension was next assembled and wheels temporarily placed. The preliminary location of the upper and lower A arms documented in a prior post was followed.
View attachment 100753
With the wheels, engine, and fuel tank mock-up in place we are almost ready to test fit the body.
It is really tight. But a wrap with safety wire can’t hurt. Good call.Make sure that the roll pin cannot fall out!