I am starting on the pedal assembly and have a few questions:
1. I have two Wildwood master cylinder kits that are 3/4 bore and one that is
7/8. Do the brakes get the two 3/4 and the clutch get the 7/8. On the last
car I built, the rear brake master cylinder was larger than the front.
2. What are the part numbers for the rods ends and rod required for the
accelerator?
3. Do all master cylinders rods need to be cut 3/4 of an inch?
Thanks
1. I have two Wildwood master cylinder kits that are 3/4 bore and one that is
7/8. Do the brakes get the two 3/4 and the clutch get the 7/8. On the last
car I built, the rear brake master cylinder was larger than the front.
2. What are the part numbers for the rods ends and rod required for the
accelerator?
3. Do all master cylinders rods need to be cut 3/4 of an inch?
Thanks